Fixing a drifting Pro 컨트롤러 is a step-by-step process that anyone with patience can follow. This 가이드 walks you through every stage, from preparing your tools to performing the actual cleaning and final testing.
What You Will Need
- Electronic contact cleaner (CRC 556 or KURE)
- Compressed air duster
- Tri-wing (Y00) and Phillips #00 screwdrivers
- Tweezers (for flat cables)
- Cotton swabs and 99%+ isopropyl alcohol
- A dry microfiber cloth
Step 1: Diagnose and Calibrate First
Connect your Pro 컨트롤러 to the Switch and navigate to System 설정 → 컨트롤러 and Sensors → Calibrate Control Sticks. Run the calibration test. If the stick fails to center properly, note the degree of drift. Even if calibration does not fix the issue, it gives you a baseline to measure improvement.
Step 2: Non-Invasive Cleaning
Before opening the 컨트롤러, try cleaning without disassembly. Tilt the stick to one side and spray a small amount of contact cleaner into the gap at its base. Rotate the stick fully in circles for 20 to 30 seconds. Wipe off any excess and let the 컨트롤러 dry for 10 minutes. Reconnect and test.
Step 3: Disassemble for Deep Cleaning
If the non-invasive method did not work, disassemble the 컨트롤러:
- Remove the four tri-wing screws from the back panel.
- Carefully lift the back shell off.
- Disconnect the 배터리 케이블 using tweezers.
- Remove the Phillips screws securing the stick module bracket.
- Lift the stick module to expose the underside contacts.
Dip a cotton swab in isopropyl alcohol and gently clean the carbon contact pads and the metal wipers inside the stick mechanism. Let everything air dry for 20 minutes.
Step 4: Reassemble and Test
Reconnect the 배터리 케이블, snap the back shell into place, and tighten all screws. Connect the 컨트롤러 to the Switch and run the calibration test again. The neutral reading should now be stable. If drift persists, the stick module itself may be worn and require replacement.
Summary
A methodical approach to drift repair yields the best results. Start with non-invasive cleaning, escalate to disassembly only if needed, and always test between steps. With the right tools and patience, you can restore your 컨트롤러 to like-new condition.